Full equipment list

Updated 2025

-10 KVA @50 Hz Northern light 843 NW3 with sound shield, electrical clutch, PTO and Gensep silent wet exhaust. TIER3 certified

Its just been serviced, new water pump impeller, fuel and oil filters etc..

-New stainless steel exhaust mixer

-NMEA200 generator control panel integrated on main panel in saloon.

-Sidepower hydraulic system, 60 litres stainless steel tank. Manual and automatic control via joystick and handles.

-240mm proportional hydraulic bow thruster

-Both hydraulic pumps are Sauer Danfoss. 

-Bowman heat exchangers.

-Ideal Hydraulic winch, stainless steel, oversized model 6H M with capstan on top.

-HBI PA60 kg, 316L stainless steel Pool N ANCHOR (Hung-Bridge Industrial co.ltd, Taiwan).

-63 kg Sarca Excel storm anchor on rope, from Anchorright Australia.

-36 Kg Sarca Exel stern anchor on rope, deployed and retrieved using the boom.

-300 feet of G70, galvanised 10mm chain, certified.

-Pullmaster hydraulic PL-2 hydraulic winch with proportional controllers for the boom/dinghy hoist and man over board situation. 2 control sjoy sticks, one near mast ond one on aft deck. 

-35 meters Dyneema rope for hydraulic winch.

-Passive Stabiliser Boom System with heavy galvanised fish.

-2 x Triple XCS Spinlocks for stabiliser rope control.

-4 x Single XCS Spinlock for sail rope control.

-Aluminium cleats on mast and stabiliser.

-4 x 34 STFS stainless steel Andersen Winches for for sail handling. 

-2 x 12 STFS stainless steel Andersen winches for stabiliser handling

-New ropes for rig
 

-2 x new Aqua Jet WPS 5.2L  seawater pumps.

 
-2 x Headhunter accumulator tanks model PT-102.
 
-2 x Headhunter pressure gauges, model PGV100.
 
-2 x Headhunter strainers, model IS-1000L.
 
-Solaris 75L stainless steel Superyacht calorifier tank from with dual AC heating elements (1kw and 2kw) + heating from Webasto diesel heater and engine. The inside is copper so no bacteria flourish and no need for replacing zincs.
 
-Webasto DBW 2016 diesel heater integrated with aircon (not commissioned).
 
-Webasto WBCP60 (60.000 BTU) twin scroll compressor, chilled reverse cycle air conditioner.
 
-Glembring 70mm insulated stainless steel exhaust with H-type flue cap, for webasto diesel heater.
 
-HEP2O Pex pipe used for fresh water, sea water systems, chilled water from air conditioner and heaters. 
 
-2 x 8 liters Flamco expansion tanks with filling valve and pressure relief valves for the air conditioning system.
-2 x SEASTAR BC 200- 11stroke steering cylinders (+2 x Kobelt spare cylinders)
 
-2 x Kobelt 7050 12” stroke steering cylinders.
 
-2 x Kobelt 7005 BLTV and BLT steering pumps (at wheels) and engine.
 
-2 x Kobelt 7201, 24V autopilot pumps.
 
-2 x Kobelt 2009 AAK gear and throttle control levers.
 
-Dual Murphy EGT gate for engine control.
 
-Stidds N500 captains chair in PH, surface mount, slimline, low back.
 
-Iveco N67-MNA150 main engine, 150 HP @ 2800 RPM, naturally aspired with front pulley for large alternator (fuel injectors have just been served, new oil, new o-rings and oil. 
 
-Sabb HVP-65E CPP gearbox with hydraulic clutch and PTO and Thermex heat exchanger.
 
-Korsoer, CP6-R, 875mm, 3 bladed CPP (controllable pitch propeller) with mild steel propeller tube and bronze / rubber bearings, water lubricated. Propeller head is grease lubricated from inside engine room.
 
-4 x Isoflex engine mounts, models M90–20-s and MD100-24-s, matched to the axial and radial limits of the Profiseal and the engine + gear weight distribution.
 
-NEW ProfiSeal, 70mm Inside bronze seal, water lubricated.

-ProfiSeal 70mm safety seal, inflatable.
 
-Chatfield Marine bronze Elite rudder seal with Vesconite bearings.
 
-3 x Seaboard Marine Double / Double filter systems for engine and generator, filters are Fleetguard FS1000 and FS19513, with electric pumps / priming kit for each set of filters.
 
-Alfa Laval MIB303 fuel centrifuge / purifier, 230V, to clean fuel tanks and used engine oil.
 
-Puradyn PFT12 scavenge engine oil filter with 24V heating element.
 
-Dual remote Iveco Oil filter system for remote installation and change over, prevents shutdown if changing filters.
 
-Dual Reverso oil change / fuel transfer systems and manifolds with Reverso Transfer pump.
 
-2 x 3” Arctic Steel, stainless steel strainers for engine raw water.
 
-1 x 1.5” SISO Arctic Steel, stainless steel strainer for port side keel cooler.
 
-All electric galley with full Baumatic suite oven, combo micro-oven, 2×2 induction cookers, hood.
 
-Fisher Paykel dishwasher. 
 
-Cruise RO water maker, 30G/hour, 220V 50Hz, expandable by adding extra pressure vessels, generic system with spares available all over the world. (not commissioned)
 
-Remote control panel in saloon to control and pickle the system.
 
-MAX-AIR 35E1-230V dive compressor, with spare parts package.
 
-2 x C130 LX Isotherm fridges in galley,
 
-1 x C42 LX Isotherm fridge on fly bridge,
 
-1 x Nova Kool LT211-F3, freezer with 3 cooling plates to ensure even cooling in freezer.
 
-Remote compressors on all fridges to allow best fit and best cooling.
 
-2 x Planus Artic toilets, 24V, with solenoid for use with fresh or seawater using the water pressure pumps.
 
-Marinco AFI-1000 horn, stainless steel.
 
-Lopo nav lights, mast head, steaming and stern lights.
 
-6 x Hella marine grade flood lights on mast, stern and forward deck lights,
 
-8 x Hella engine room ceiling lights,
 
-3 x Hella wet room toilet ceiling lights,
 
-Other interior lights are all Roca lights.
 
-9 x Interior Caframo ventilation fans, model Bora, 3 speed.
 
-1 x 9” Delta T ignition protected engine room fans, 24V, installed inside protected engine room ventilation duct. 
 
-10 x Vetus, 24V circulation fans in all cabins and PH.
 
-2 x Air-Only passive inlet ventilators, water proof, under FB.
 
-Victron 24V, 120V, 3000W inverter.
 
-2 x Victron Quattro’s 24V, 5000W
inverter/chargers.
 
-Victron 3.6Kva isolation transformer.
 
-Victron 7.0Kva isolation transformer.
 
-BEP built AC main control panel with Mastervolt Quattro’s and inverter, generator etc.
 
-NEW 5 x 200A, 12V AGM batteries for engine start, generator start and radio battery.
 
-NEW 2 x 200A AGM house batteries with Mastervolt BMS.
 
-Mastervolt BMS controls the Quattro inverter / chargers solar chargers, wind charger and Balmar regulator though relays.
-Balmar 97-24-140 IG, 140A, 24V brushless alternator with TSP 24, voltage spike protector.
 
-Replaced most NMEA 2000 cables with new ones.
 
-Mastervolt alternator charge controller.
 
-Galleymate 900 stainless steel BBQ.
 
-6 x Solara S665M43 semi-flexible solar panels on fly bridge Bimini.
-Mastervolt Chargemaster 60 MPPT charge controller.
 
-2 x 450W hybrid wind and solar charge controllers for wind generator and aft solar panels.
 
-2 x 70W Sunware Sw-3266 solar panels on aft railing, adjustable brackets.
 
-400W Silentwind wind generator on high pole. Most silent type. (wind generator has been removed). 
 
-Tinned BEP marine grade electrical cables.
 
-KVH M5, satellite TV dome on aft railing. Control panel in the Saloon. 
 
-BEP Czone network.
 
-3 x Simrad NSS12 MFD’s (displays).
 
-1 x Simrad OP40 remote control head to control AP and MFD’s in PH.
 
-2 x Simrad NAC-3 autopilot steering computers.
 
-2 x Simard RF300 RFU (rudder feedback unit).
 
-Simrad BSM 2 echo sounder 
 
-Simrad NAIS400 AIS.
 
-Simrad RC-42, fluxgate compass.
 
-Simrad HS-70 GPS compass.
 
-Simrad HALO3, multifunction radar.
 
-Suunto D-135 magnetic compass with correction balls and global alignment. It has been swung. 
 
-Icom 801E SSB, with AT 141 tuner and rope antenna. (not commissioned)
 
-Icom 604 VHF with AC antenna.
 
-Nexus NX 2500 VHF with navtext and NX2600 antenna, as back-up radio.
 
-Mast mounted SureCall Cellmate CM288 antenna, omni directional antenna for 2G,3G,4G, LTE, WLAN, cellular, PCS and AWS frequencies (worldwide).
 
-AC Marine WIFI power over ethernet antennas.
 
-Locomarine Standard Wifi router for satellite Wifi, and 4G.
 
-Echopilot FLS 3D forward looking sonar with dual transducers, 316L stainless steel through hulls. Dual control panels for FB and PH.
 
-Maretron WS100 weather station on mast.
 
-Maretron water flow sensors on engine water intake hose.
 
-Maretron DSM150 control and information screen.
 
-2 x Maretron TMP100 temperature model with sensors.
 
-2x Maretron SIM100 module.
 
-Marinco 502-2, 24V, remote controlled search light, hard wired dual station joystick, mast mounted to prevent back shine from deck.
 
-BEP ultrasonic level sensors for fuel and blackwater, float sensors for water tanks, all integrated into Simrad nav system for display. (the ultrasonic sensors need to be replaced with float sensors). 
 
-Carling control switches for all PH and FB controlled systems.
 
-Fusion 700 stereo and radio.
 
-6 x PolyPlanar marine speakers for stereo.
 
-4 x Fusion NRX2000 remote control panels outside and inside, these panels can show NMEA 2000 information.
 
-Splendide 2100XC vented washer / drier, 120V, 60Hz, in Saloon cabinet. 
 
-400mm clearview screen for centre window (no vipers).
 
-2 x Rocca water solenoid for fresh water washing of 2 side windscreens.
 
-2 x Diamond Seaglaze weatherproof Dutch PH doors.
 
-1 x Diamond Seaglaze weatherproof French door in Saloon.
 
-6 mm cork insulation under all floors.
 
-Mascoat Delta DB sound insulating paint on inside of hull.
 
-3” expansion from on hull, sprayed with fireproof epoxy.
 
-4 x CAE water faucets on extendable flexible hoses for all sinks.
 
-3 x Whale 2-gallon grey water tanks to collect air conditioner condensation.
 
-3 x Whale Gulper 220 pumps to empty them.
 
-5 x Rule 3000 bilge pumps, all hoses installed with gooseneck.
 
-5 x Ultra Pump Senior 24V bilge pumps switches to activate the Rule bilge pumps.
 
-Intervac built-in vacuum cleaner, with hose set to reach all of boat.
 
-CCTV cameras installed in engine room, the mast and as stern camera. Displayed on MFD’s.
 
-Stainless steel water / air separator screen in air intake for E/R.
 
-Zodiak 6 person Offshore life raft, in canister.
 
-Shakespeare digital TV antenna.
 
-2 x 50A Smartplug shore power receptacles.
 
-50 meter heavy duty shore power cable.
 
-Seafire FDM1000M automatic/ manual fire extinguisher with manual override switch.
 
-UV steriliser for fresh water, 24V, model Idromar UV5000H (not commissioned). 
 
-Articulated rudder designed by Naval Architect Mr Roos, DK.
 
-Electrical drawings from Toplogic, NZ, complying with AS/NZS 3004
 

-New fly bridge table, new pilot house table and new dinign table, all larger than original.

-2 x 12V high amp power outlet on the aft deck for fishing equipment, like Cannon Downrigger.

-2 x removable fish cutting boards inside aft cockpit.

-New swim plat form, can be raised or lowered as required for cruising or anchoring, provides extra protection aft deck (the swim ladder doesn’t work well and need re-thinking before replacing)

-New forward deck sofa cabinets with storage for ropes, fenders etc.

-New Kiwi grip deck paint.

-New aft deck hatch, larger, with 4 locks.

-New electrical system drawings

-New hydraulic system drawings

-New nav system drawings

-New engine safety shutdown drawings

-Livingston type FRP dinghy (3 meter).

-Tohatsu 9.8 HP petrol outboard motor.

-ePropulsion Spirit 1 electrical outboard motor

-2 x kayaks and a large floating square